HAZARD - Blade sharpening and balan-
cing adjustment, including removal and
reasons, these operations must be carri-
The same applies to blade replacement
with a new one.
-
MACHINE
Do not use high-pressure nozzles or aggressive
liquids to wash the casing and the engine.
ENGINE
-
To service the engine, follow the instructions in the
attached engine manufacturer’s manual.
- At the start of each season, check the machi-
ne and have it serviced by a specialised after-
sales centre.
GRASS BAG
strong jet of water.
BLADE DECK
Washing the inside of the blade deck and of the
grass unloading pipe can be done as follows:
1)
2)
sit in the seat and engage the parking brake;
move the gear lever to neutral (N);
5) move the blade deck to minimum level (full
down);
6) start the engine;
allow the blade to turn for a few minutes.
Release the bag and rinse it with a strong jet of
water.
follow the instructions in the chapter: “Ba-
-
ph "1.4" maintenance and deposit.
HAZARD
this is torn, unstitched and shows damage
HAZARD Due to the possible launching
blade.
HAZARD -
inspection, cleaning and servicing
operations on the machine, and be-
fore unblocking the grass unloading
pipe, stop the engine, take out the
in the manual.
The blades are sharp:
-
re cleaning, inspecting and repairing
cutting parts, stop the engine and
-
nect the spark plug wire, and keep the
-
Hot surfaces: danger of
burns.
or servicing the engine itself.
Wear adequate clothes
and work gloves to clean the blade
and the blade deck and in all situa-
-
ds.
Never throw old oils, pe-
into the environment.
To Next Page
Loading...
