4 | English
MAINTENANCE
Ŷ The product should never be connected to a power
VXSSO\ ZKHQ DVVHPEOLQJ SDUWV PDNLQJ DGMXVWPHQWV
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product from the power
supply will prevent accidental starting that could cause
VHULRXVLQMXU\
Ŷ :KHQ VHUYLFLQJ XVH RQO\ RULJLQDO PDQXIDFWXUHU¶V
replacement parts, accessories and attachments.
Use of any other parts may create a hazard or cause
product damage.
Ŷ Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
Ŷ Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
LQMXU\
Ŷ For greater safety and reliability, all repairs should be
performed by an authorised service centre.
SYMBOLS ON THE PRODUCT
Safety alert
CE conformity
V Volts
Direct current
min
-1
Revolutions or reciprocations per minute
Chuck capacity
No load speed
Drilling without impact
Percussion drill
EurAsian Conformity Mark
Please read the instructions carefully
before starting the machine.
Ukrainian mark of conformity
:DVWHHOHFWULFDOSURGXFWVVKRXOGQRW
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authority or
retailer for recycling advice.
SYMBOLS IN THIS MANUAL
Note
Parts or accessories sold separately
Torque, maximum
Torque, minimum
Speed, minimum
Speed, maximum
To Next Page
Loading...
Need help?
General
