TO START A COLD ENGINE
See figure 9
2. Place the engine switch to the on “I” position.
3. PRIME – press the primer bulb 10 times slowly.
4. SET the the choke lever to the “START” position.
5. Lock the throttle by squeezing throttle trigger and trigger lock together and pressing in the lock
button.
6. PULL the starter rope with a quick firm and consistent motion unitl the engine fires or
starts to fire (Max “6” pulls).
7. If the engine fires(pops) but does not continue to run, move the choke lever to the “RUN”
position and continue to start the engine.
8. If the engine starts and runs, pull the throttle trigger to release it from the throttle lock position
and move choke lever to the “RUN” position.
9. Allow the engine to warm up for 5-20 seconds. If the engine does not start, repeat from
procedure 3.
TO START A WARM ENGINE
1. With the engine switch on “I” position, PULL the starter rope with a quick firm and consistent
motion until the engine starts (Max “4” pulls).
NOTE: Do not use the choke when starting a hot engine, make sure the choke lever is in
the “RUN” position.
TO STOP THE ENGINE
Press the engine switch to the stop “O” position. Wait until the engine stops.
OPERATING THE POST HOLE DIGGER
See figure 10 & 11
Hold the post hole digger in front of you with the right hand firmly gripping on the throttle
handle and your left hand firmly gripping the other.
Always keep a firm grip with both hands while in operation.
The post hole digger should be held at a comfortable position with the operation bracket frame
no higher than waist level.
The throttle trigger helps control the speed of the auger to suit various ground conditions.
Always pay full attention to your operation. Serious injuries may result if contact is made
with the rotating auger.
NOTE: Your post hole digger is supplied with a 300mm extension shaft to be used for
deeper hole digging. DO NOT start digging a hole with the extension attached.
The hole should always be started with the auger bit only fitted. Once the hole is deep enough
Two feet stand from a firm ground.
Slightly lean the support frame on your thighs or waist.
15
1. Remove auger bit (if attached).
NOTE: Always test the safety device before operating the auger bit.
To Next Page
Loading...
