CLEANING THE EXHAUST PORT AND MUFFLER
Depending on the type of fuel used, the type and amount of oil used, and/or your operating
conditions, the exhaust port and muffler may become blocked with carbon deposits. If you
notice a power loss with your petrol powered tool, a qualified service technician will need to
remove these deposits to restore performance.
STORING THE PRODUCT
Clean all foreign material from the product. Store idle unit indoors in a dry, well-ventilated area
that is inaccessible to children. Keep away from corrosive agents such as garden chemicals.
Abide by all ISO and local regulations for the safe storage and handling of petrol.
WHEN STORING FOR 1 MONTH OR LONGER
Drain all fuel from tank into a container approved for petrol. Run engine until it stops.
SPARK ARRESTOR REPLACEMENT
This machine is fitted with a spark arrestor to help prevent fires. The spark arrestor is fitted at the
muffler discharging port. To ensure proper performance of your product, the spark arrestor must
be cleaned or replaced every 25 hours or each year. Please contact your nearest service dealer
for a new spark arrestor.
To find your nearest service dealer please call the CUSTOMER SERVICE CENTRE on
1300 361 505 or find it on our website.
IDLE SPEED ADJUSTMENT
See figure 18
If the auger attachment turns at idle, the idle speed screw needs adjusting on the engine.
Turn the idle speed screw counterclockwise to reduce the idle RPM and stop the auger
attachment movement. If the auger attachment still moves at idle speed, contact a service
dealer for adjustment and discontinue use until the repair is made.
SPARK PLUG REPLACEMENT
See gure 15
This engine uses an NGK BPMR6A or Champion RCJ6Y spark plug with 0.60 (+/- 0.1)mm
electrode gap. Use an exact replacement and replace annually. Make sure new spark plug
is secured in place with a torque up to 12N.m.
18
See figure 19
To Next Page
Loading...
