13
The following tools (not included or drawn to scale) are needed for assembly and making adjustments:
TOOLS NEEDED
FEATURES
BLADES
For maximum performance, it is recommended that you use
the 24-tooth, 10 in. carbide-tipped combination blade pro-
vided with your saw. Additional blade styles of the same high
quality are available for specific operations such as ripping.
Your local dealer can provide you with complete information.
Kerf width must be within the limits stamped on the spreader/
riving knife.
WARNING:
Do not use blades rated less than the speed of this tool.
Failure to heed this warning could result in personal injury.
C-CLAMPS
Fig. 4
FRAMING SQUARE
PHILLIPS
SCREWDRIVER
FLATHEAD
SCREWDRIVER
SOCKET WRENCH
WITH 10 mm AND
11 mm SOCKET
COMBINATION
SQUARE
To Next Page
Loading...
