Ryobi RTS30 - Moving and Storing the Table Saw

21
ASSEMBLY
TO MOVE THE LEG STAND
See Figure 17.
 Holding the leg stand firmly, pull the leg stand toward you
until the leg stand and saw are balanced on the wheels.
 Push the saw to the desired location then either open the
leg stand for immediate saw operation or store the saw
in a dry environment.
TO INSTALL DUST BAG
See Figure 18.
 Slide the elbow inside the dust chute on the back of the
table saw.
NOTE: For efficient operation, empty the dust bag before
it is half full. This will permit better air flow through the bag.
TO STORE THE TABLE SAW ACCESSORIES
See Figures 19 - 20.
The table saw has two convenient storage areas (one on
either side of the saw cabinet) specifically designed for the
saw’s accessories.
When not in use, store the accessories securely by snapping
each accessory in place.
Fig. 18
DUST
BAG
DUST
CHUTE
ELBOW
Fig. 19
Fig. 20
MITER
GAUGE
RIP FENCE
BLADE
WRENCHES
STORAGE
HOOK
PUSH STICK
Fig. 17