16
To choose your own image for use as the watch face,
follow these steps. In the 'Device' menu, tap on 'Watch
Face Market', then swipe up the screen to select ‘Photo.’
Follow the prompt instructions, tap ‘Add and Install’ and
wait until completion to load the chosen image onto
your watch.
10.3.3 SETTING MESSAGE NOTIFICATION FEATURE ON YOUR
WATCH
With the feature enabled, the Ryze Elevate Smart
Watch will receive notifications of messages on your
smartphone when the watch stays Bluetooth connected
with the running App. To enable or disable this function,
follow the steps below:
• Open the App. In the ‘Device’ menu, tap on
‘Notifications.’ Find and tap on ‘Select to set
Notification Access.’ Then scroll down the list to find
the ‘Ryze Connect’ App and slide the button next to
the App to toggle message notifications ON or OFF.
To enable or disable message notifications from a
messaging application on your smartphone, follow the
below steps:
• Open the App. In the ‘Device’ menu, tap on
‘Notifications.’ Find the corresponding App and slide
the button next to it to the ON or OFF position.
• Tap '<' to save the watch settings.
• Return to ‘Home’ menu and synchronise the watch
again.
10.3.4 SETTING UP AN ALARM ON THE WATCH VIA THE APP
In the ‘Device’ menu, tap on ‘Alarm
Clock’ and select ‘Add Alarm.’ Choose
your setting for alarm as required. Tap
on ‘
’ in the upper right to confirm.
Once an Alarm is added, slide the
button next to the Alarm to toggle the
alarm ON or OFF.
10.3.5 SETTING UP CONTINUOUS HEART RATE MONITORING ON
YOUR WATCH
By default, your heart rate will be measured in real time
when an exercise session is initiated regardless of the
setting for ‘Continuous HR Measurements.’
To enable or disable the continuous heart rate
monitoring function on your watch, follow the below
steps:
• Open the App. In the ‘Device’ menu, tap on ‘Health’
and select ‘HR monitoring.’ Slide the button next to
‘Continuous HR Measurements’ to toggle it ON or
OFF.
To Next Page
Loading...