CHARGE PLUS Models CBHF1SM, CBHF1-V2, CBHF2 Page 8 of 12
USERS MANUAL
4. YELLOW CONTROL INDICATOR: WHEN THIS LED IS LIT, THE FINAL
PHASE OF THE CHARGING CYCLE HAS STARTED.
5. GREEN CONTROL INDICATOR: WHEN THIS LED IS LIT, THE
CHARGING CYCLE HAS FINISHED.
INTRODUCTION
THE CHARGE PLUS BATTERY CHARGER IS A HIGH FREQUENCY, MICROPROCESSOR
CONTROLLED CHARGER DESIGNED TO OPTIMIZE BOTH BATTERY CAPACITY AND
OVERALL BATTERY LONGEVITY. IT PLUGS DIRECTLY INTO A STANDARD 120V A/C
OUTLETS FOR USE IN OFF-BOARD (SHELF) APPLICATIONS. THIS CHARGER
FEATURES FULLY-AUTOMATIC OPERATION AND LED’S WITH STATUS SCREEN TO
MONITOR CHARGE CYCLE AND STATUS.
STORAGE
WHEN STORING THE CHARGER, BE SURE THAT IT IS STORED INDOORS IN A CLEAN
AND DRY ENVIRONMENT. IF POSSIBLE, THE CHARGER SHOULD BE STORED IN ITS
ORIGINAL PACKAGING. THIS WILL HELP PROTECT THE CHARGER FROM ANY DUST
OR ABRASION. IT SHOULD BE STORED IN AN AREA WHERE IT IS NOT LIKELY TO BE
DAMAGED. DO NOT STACK ANYTHING ON TOP OF THE CHARGER.
BATTERY TYPE
THIS CHARGER IS DESIGNED TO CHARGE DEEP-CYCLE LEAD ACID BATTERIES OF
WET/FLOODED, AGM (ABSORBED GLASS MAT), GEL DESIGN, OR LITHIUM.
CHARGER OPERATION
UNPACK YOUR CHARGER AND INSPECT FOR ANY DAMAGE.
IF YOUR CHARGER COMES WITH AN OPTIONAL VEHICLE PIGTAIL,
PLEASE ATTACH IT TO THE CONNECTED SB50 ANDERSON
CONNECTOR.
PLUG THE A/C CABLE INTO AN AVAILABLE 120VAC OUTLET.
CONNECT THE D/C CABLE TO THE BATTERY PACK CONNECTOR ON
THE VEHICLE.
ONCE CONNECTED, THE CHARGE PLUS WILL START TO DISPLAY A
SEQUENCE OF DETAILS ON THE CHARGERS INTERNAL
PROGRAMMING.
To Next Page
Loading...
