S.R.Smith CYCLONE - Cyclone Assembly

8
Cyclone Assembly
1. Place the upper & lower slide runway sections on the ground. Assemble and fasten as shown in
FIGURE C.
2.
a. Attach the pedestal to the upper & lower slide sections as shown in FIGURE D in 2
locations.
b. Attach the pedestal as shown in FIGURE D in 4 locations. Mark and drill a 1/4" pilot hole
in the center of each recess before fasting with the lag screws.
3. Attach the assembled slide runway to the ladder using the hardware shown in FIGURE E.
(5)
(4)
(5)
(4)
(6)
2.a.
2.b.
(7)
(4)
(1)
(2)
(4)
(5)
(4)
FIGURE D
FIGURE E
FIGURE C