2-4 5th Ed. Feb 15, 08
S–TEC
ACTION RESPONSE
10. Press HDG / GPSS Selector
Switch.
GPSS lamp is illuminated and HDG
lamp is extinguished on HDG / GPSS
Selector Switch, as an indication that
GPSS Converter’s GPSS mode is
engaged. This is shown in Fig. 2-1b.
11. Turn Heading Bug to the left side
and right side of Lubber Line.
A/C Control Wheel does not respond.
Note: The GPSS mode cannot be tested since there is no groundspeed.
12. Disconnect autopilot. ------
Table 2-1. Pre-Flight Test (continued from page 2-3)
Fig. 2-1. HDG / GPSS Selector Switch
To Next Page
Loading...