3 (Trip Information): Press this button to
display the odometer, trip odometers, and timer.
See DIC Operation and Displays on page 195
for more information.
| (Hazard): Press this button to turn the hazard
warning flashers on and off. See Hazard Warning
Flashers on page 150 for more information.
q (Customization): Press this button to access
the vehicle settings menu and customize the
personal settings on your vehicle. See DIC Vehicle
Customization on page 205 for more information.
r (Select): Press this button to reset certain
DIC functions and set your customization settings.
Pressing any of the DIC buttons will acknowledge
DIC messages and clear them from the DIC
display.
DIC Operation and Displays
The DIC comes on when the ignition is on. After a
short delay the DIC will display the information
that was last displayed before the engine
was turned off.
If a problem is detected, a warning message will
appear on the display. Pressing the trip stem
on the instrument panel cluster or any of the
DIC buttons will acknowledge any warning
or service messages.
You should take any message that appears on the
display seriously and remember that clearing
the message will only make the message
disappear, not correct the problem.
The DIC has different modes which can be
accessed by pressing the four DIC buttons located
on the center of the instrument panel, above the
radio. These buttons are fuel information, trip
information, customization, and select. The button
functions are detailed in the following pages.
195
To Next Page
Loading...
