Finding a Category (CAT) Station
(XM™ Satellite Radio Service Only)
To select and find a desired category perform the
following:
1. Press the CAT button to activate category
select mode. The current category displays.
2. Turn the tune knob to select a category.
3. Once the desired category is displayed, press
either SEEK arrow to go to that category’s
first station.
4. To go to another station within that category
and the category is displayed, press either
SEEK arrow again. If CAT times out and is no
longer on the display, go back to Step 1.
5. Press CAT to exit category select mode or
wait for CAT to time out.
If the radio cannot find the desired category, NOT
FOUND displays and the radio returns to the
last station you were listening to.
Radio Messages
CAL ERR (Calibration Error): The audio system
has been calibrated for your vehicle from the
factory. If CAL ERR displays it means that
the radio has not been configured properly for
your vehicle and it must be returned to your
dealer for service.
LOC (Locked): This message is displayed when
the THEFTLOCK
®
system has locked up. Take
your vehicle to your dealer for service.
If any error occurs repeatedly or if an error cannot
be corrected, contact your dealer.
Radio Messages for XM™ Only
See XM Radio Messages on page 239 later in this
section for further detail.
Playing a CD
Insert a CD partway into the slot, label side up.
The player pulls it in and the CD should begin
playing. To insert a CD with the ignition off, first
press the eject button or the DISP (display) knob.
218
To Next Page
Loading...
