Saab R5 Supreme - Page 98

R5 SUPREME - Navigation System
OPERATION
7000 118-301, A Page 98
5.11.5 Currently Selected Beacon
The Currently Selected Beacon view shows information related to the R4 DGPS
Navigation Sensor‘s beacon reception. The view is only accessible if an R4 DGPS
Navigation Sensor is used as navigation sensor. The following information is displayed:
Figure 84 – Currently Selected Beacon
Station ID:
The reference identity of received corrections from the tuned beacon
station.
Station Name:
Name of the beacon station.
Beacon Id:
The Id for the beacon transmitter from which corrections are
received.
Range:
Current range to the beacon station from which currently used
corrections are received.
Freq:
The frequency of the currently selected beacon station.
(Freq) Mode:
The frequency tuning mode which can be Manual, Auto or
Database.
Bitrate
Beacon receiver bit rate.
(Bitrate) Mode:
Beacon receiver bit rate selection mode: Manual or Auto.
Signal:
Signal strength of the received beacon signal.
SNR:
Signal to noise ratio. All values above 15 are good SNRs for the
beacon signal.
WER:
Word error rate, percentage of bad data words in the last 25 words
received.
Health:
Health indication received from the tuned beacon station.
Firmware:
Firmware version for the internal beacon receiver.
Throughput:
Message throughput.