GB GB
56 57
5. Change the refrigerator door:
1) Remove the cover plate of the upper end cover of the refrigera-
tion door and the left decorative cover.Install the upper shaft sleeve
and the signal line terminal 1 of the door body to the other side
and cover the upper end cover plate. Take out the right decorative
cover from the accessory bag and install it to the other side of the
upper end cover.
2) Remove the door self-locking, door stop and shaft sleeve of the
refrigeration door, take out the left door self-locking from the
accessory bag, install it on the left side of the lower end cover of the
refrigeration door, change the door stop and shaft sleeve to the left
side of the lower end cover of the refrigeration door.
6. Change the freezing door:
1) Remove the shaft sleeve and cap of the upper end cover of the
freezing door and install them at the left and right swap positions.
2) Remove the door self-locking, door stop and shaft sleeve of the
freezing door, take out the left door self-locking from the accessory
bag, install it on the left side of the lower end cover of the
freezing door, change the door stop and shaft sleeve to the left side
of the lower end cover of the freezing door.
a t sn i neht , egn i h r ewo l eht no r ood gn i zee r f deca l pe r eht l l a t sn I . . 7
the middle hinge and cover the hinge hole decorative cover.
8. Remove the upper left hinge cover and upper left hinge from the
accessory bag.Place the refrigerated door body on the middle hinge
and install the upper left hinge.Connect the refrigerator top signal
To Next Page
Loading...
