Mark points on the lines making sure their perfect
horizontal alignment
• Mark 3 points (1) on A line, at 80 mm at both sides, including
the central mark on the reference line (you may better use the
bracket 20 to mark easily the points)
• Mark 2 points (2) on B line, at 60 mm at both sides of the
vertical reference line�
• Mark 2 point (3) on C line, at 60 mm at both sides of the
vertical line�
Fix the brackets:
• Drill holes at the marked points with a Φ10 mm drill bit�
By measure of precaution, it is recommended to drill the holes at
points (2) on B line only once the lower chimney with bracket 21
is assembled on the hood unit� (refer to Fig�2)�
It allows to verify if the holes of the bracket are precisely on-line
B otherwise mark new points directly from the bracket after
assembly�
• Insert the Wall Plugs 11 into the holes�
• Fix the hood xing bracket 20 with 3 screws 10 (5 x 50) at the
horizontal line A�
• Fix a Chimney xing bracket 21 with 2 screws 10 (5 x 50) at
the horizontal line C�
30
GB
To Next Page
Loading...
