SABROE ATLAS V619 User Manual

INTERRUPTION OF OPERATION
In the below table, some of the operational difficul ties,
which might arise, are shown together with the effects they
have on the machine and remedies for possible defects.
For all type of flake ice mach ines
Effect
.
Uneven formation of
ice, especiaIly in
vertical stripes.
The ice is crushed
because of diffi-
culties with the
ice slipping the
drum.
The movements of
the drum are ir-
regular and take
place in small
jerks.
Cause
Insufficient
water supply
Calcareous deposit
on the drum.
.-
-~
--
Water to be frozen
too soft.
Ice has forme d
under the drum
around the shaft
and the stuffing
box; this brakes
the movements of
the drum.
Remedy
Control float valve
and water supply
Clean distribution
pipe (2.1).
Clean filter.
Clean the drum.
See instruction book
under "Maintenance" ,
page 27. _-----
- "'" .. ---- ~- --_ ..•.. _-----_.-_.
--
Use the salt dosing
device.
Stop the machine and
the compressor imme-
diately.
Defrost by flushing
with a water hose
under the drum.
Do not start the
mach ine until the
ice under the drum
has melted away, as
otherwise the gear
might break.
Control that suffi-
cient water is
sprayed underneath
the drum. An insuf-
ficient water spray
cou1d be caused by a
too low water pres-
sure (has to be
above 1 bar) or by a
leak in the hose
(2.3) between the
float va1ve (2.10)
and the nozz1e
(2.02).
35

SABROE ATLAS V619 Specifications

General

Brand	SABROE
Model	ATLAS V619
Category	Ice Maker
Language	English