SACKit BOOMit - Connect Two BOOMit with Line In; Power Bank Function; Cleaning the Speaker

9
• Turn on your speaker by turning the volume button.
• If the ‘AUX/Bluetooth’ LED is bright blue (indicating Bluetooth
connection), press the ‘source’ button once and the ‘source LED’ will
go from blue to green (indicating line in mode).
CONNECT TWO BOOMit with LINE IN
Two BOOMit can be connected through AUX / line in. If connected with
another BOOMit the second one will replicate the output for double effect.
• Connect the first BOOMit with a device through Bluetooth.
• Insert the AUX cable in the first BOOMit.
• Turn on the second BOOMit and press the “Source” button until
Bluetooth/AUX led turns green.
• Plug in AUX cable in second BOOMit, and turn up the volume to
max.
This function allows you to connect up to four BOOMit together. First pair two
BOOMit with Bluetooth, then connect each of those BOOMit to another set of
BOOMit using the line in method described above.
POWER BANK FUNCTION
• Turn on BOOMit
• Use a compatible USB cable and connect to your device you wish to
charge.
• Max output is 5V/1.5A.
CLEANING THE SPEAKER
1. Please turn off the speaker before cleaning.
2. Use only water and a mild detergent on a damp cotton or microfibre
cloth for cleaning the speaker.
3. Do not use any solvents or similar to avoid damaging the surface.
4. During cleaning please take extra care not to spill water in any of the
connectors.