7
• Lin in / out: Mini-jack connector. Use this dual function connector
for:
• When in Bluetooth mode, use this to transfer the speakers
signal to other units by cable.
• When in AUX mode, use this to receive signal from another unit.
• Note: Can be used to connect two BOOMit with a mini-jack
connector.
• USB-power outlet. Use this port for charging your phone or similar
with the large internal battery.
• Bass reflector port for increase bass. Do not block or fill the port as
this will impact the sound quality.
QUICK START GUIDE
• Connect the speaker to a power source and charge at least 6 hours
to obtain full battery capacity.
• Turn on speaker by turning the Volume/ON button clockwise.
• Turn on Bluetooth on the device you want to connect.
• Choose “BOOMit” in the Bluetooth settings on your device. Enter
pin ‘0000’ if asked.
• Start playing music from your device.
• To disconnect the existing device connected to your BOOMit
double click ”Source” button.
BATTERY AND CHARGING
Please use the adaptor supplied with BOOMit for charging, the adaptor
power is 15V/2A. Do not use any other power adaptor.
• Before use you should charge the speaker for at least 6 hours to
obtain full battery capacity.
• If the speaker is fully discharged it will take 3 hours to fully charge
the internal battery.
• When charging the power led will illuminate and will turn of when
fully charged.
To Next Page
Loading...