• (Fig.11) - Turn the filter-holder from left to right until
it locks in place.
• (Fig.12) - Take 1 or 2 preheated cups and place
them under the “Crema” filter-holder; check
that they are correctly placed under the coffee
dispensing holes.
• (Fig.13) - Press the coffee button (4).
• When the desired quantity of coffee has been
obtained, press the coffee button again (4) to stop
the dispensing of the coffee and remove the cups
of coffee (Fig.14)
.
• (Fig.15) - Wait a few seconds after dispensing,
then remove the “Crema” filter-holder and empty
the remaining coffee grounds.
Note for cleaning: Keep the filter of the
“Crema” filter-holder clean by removing it
and washing it with drinking water (Fig.16).
5.2 Coffee pods
• (Fig.8A) - Remove the ground coffee filter (14)
from the “Crema” filter-holder (13) by pulling
it up.
• (Fig.9) - Insert the coffee pod adapter (17),
with the curved part facing down, into the
“Crema” filter-holder (13); then insert also the
filter (16).
• (Fig.10) - Insert the “Crema” filter-holder in the
brew unit from the bottom (8).
• (Fig.11) - Turn the filter-holder from left to right until
it locks in place.
• Release the grip from the “Crema” filter-holder. The
handle is automatically turned slightly towards the
left.
This movement assures the perfect functioning
of the “Crema” filter-holder.
• (Fig.13) - Preheat the “Crema” filter-holder by
pressing the coffee button (4). Water will spill out
of the “Crema” filter-holder (this operation is only
necessary for the first coffee).
• After 50cc of water has flowed out, press
the coffee button (4) again to stop hot water
dispensing.
• (Fig.15) - Remove the “Crema” filter-holder from
the machine by turning it from right to left and
emptying out the remaining water.
• Insert the pod in the filter-holder; make sure
the paper from the pod does not overhang the
filter-holder.
• (Fig.10) - Insert the “Crema” filter-holder in the
brew unit from the bottom (8).
• (Fig.11) - Turn the filter-holder from left to right until
it locks in place.
• (Fig.12) - Take 1 preheated cup and place it under
the filter-holder; check that it is correctly placed
under the coffee dispensing holes .
• (Fig.13) - Press the coffee button (4).
• When the desired quantity of coffee has been
obtained, press the coffee button again (4) to
stop dispensing and remove the cup of coffee
(Fig.14)
.
• (Fig.15) - Wait a few seconds after dispensing,
then remove the filter-holder and dispose of the
used pod.
Note for cleaning: keep the filter of the
“Crema” filter-holder clean by removing it
and washing with drinking water (Fig.16).
6 TIPS FOR CHOOSING COFFEE
As a general rule any type of coffee available on the
market can be used.
However, coffee is a natural product and its flavour
changes according to its origin and blending; it is
therefore a good idea to try different types, in order
to find the most suited to your personal taste.
For best results we recommend using blends which
are specially prepared for espresso machines.
Coffee should always be dispensed by the “Crema”
filter-holder without dripping.
The speed of coffee dispensing can be modified by
slightly changing the amount of coffee in the filter
and/or using a different coffee grind.
BEFORE PERFORMING ANY OPERATION
CONNECTED TO STEAM OR HOT WATER
To Next Page
Loading...
