DISPENSING, CHECK THAT THE STEAM
NOZZLE (PANNARELLO OR CAPPUCCINATORE)
IS DIRECTED OVER THE DRIP TRAY.
7 HOT WATER DISPENSING
Danger of scalding!
Dispensing may be preceded by short
sprays of hot water. The dispensing nozzle can
reach high temperatures: do not touch it with
bare hands.
• (Fig.4) - Turn on the machine, if not already on,
with the main switch (2); the LED (3) lights up.
• Wait until the machine ready LED (5) lights up.
• (Fig.17) - Place a container or a tea glass under
the steam nozzle (pannarello).
• Open the “hot water/steam” knob (7) by turning it
anti-clockwise.
• (Fig.18) - Press the coffee button (4) to dispense
water until the desired quantity is reached.
• When the desired quantity of hot water has been
dispensed, press the coffee button again (4).
• (Fig.19) - Turn the knob (7) clockwise to close the
tap.
• Remove the container with hot water.
8 STEAM DISPENSING
Danger of scalding!
Dispensing may be preceded by short sprays
of hot water. The brewing nozzle can reach high
temperatures: do not touch it with bare hands.
• (Fig.4) - Turn on the machine, if not already on,
with the main switch (2); the LED (3) lights up.
• Wait until the machine ready LED (5) lights up.
• (Fig.20) - Press the steam switch (6). The machine
ready LED (5) switches off.
• Wait until the ready machine LED (5) lights up
again. The machine is now ready for steam
dispensing.
• (Fig.17) - Insert a container below the steam
nozzle and open the “Hot water/steam” knob (7)
for a few seconds, so that remaining water exits
from the steam nozzle (pannarello); in a short
time only steam will come out.
• (Fig.19) Close the knob (7) and remove the
container.
• (Fig.21) - Immerse the steam nozzle in the
drink to be warmed and open the knob (7); turn
the container with slow upward movements so
that it is warmed evenly.
• (Fig.22) - After using the steam for the desired
time, close the knob (7); remove the container
with the warmed beverage.
• (Fig.20) - Press the steam switch again (6).
• Proceed with circuit recharging as described in
par. 4.5 to make the machine ready for use.
• (Fig.23) After this operation, clean the steam
nozzle with a damp cloth.
9 PREPARING CAPPUCCINO
Danger of scalding!
When starting dispensing short sprays of
hot water may come out. The brewing nozzle can
reach high temperatures: Do not touch it with
bare hands.
• (Fig.4) - Turn on the machine, if not already on,
with the main switch (2); the LED (3) lights up.
• Wait until the machine ready LED (5) lights up.
• (Fig.20) - Press the steam switch (6). The machine
ready LED (5) switches off.
• Wait until the ready machine LED (5) lights up
again. The machine is now ready for steam
dispensing.
• Turn the pannarello 90° clockwise and extract it.
To Next Page
Loading...
