31 2 4
75 6 8
119 1210
DESCALING
Flashing
Flashing
When the machine needs
descaling, the indicator light
ashes.
Fill the tank up as previ-
ously described to prepare
the descaling solution.
Place a large enough con-
tainer under the steam
wand.
Open the knob.
The descaling cycle starts.
Close the knob.
Remove the container.
Rinse and ll the tank with
fresh drinking water.
Place a large enough
container under the steam
wand.
Open the knob and rinse.
The solution is dispensed
at regular intervals.
When the indicator lights
ash, the descaling cycle is
complete.
Press the button for 5 sec-
onds.
Limescale normally builds up with the normal use of the appliance. The machine is supplied with a software that warns the
user about the need to run a descaling cycle.
Use the Saeco descaling solution only: it has been specially designed to comply with the technical
speci cations of the machine, to ensure the machine performance will not decrease over time,
and to guarantee a safe and risk-free use. The descaling solution must be disposed of according
to the manufacturer’s instructions and/or applicable regulations in the country of use.
Never drink the descaling solution and any substances dispensed until the cycle ends.
Never use vinegar as a descaling solution.
For a correct preparation of the descaling solution, pour the entire content of the Saeco concentrated
descaling solution into the water tank, and ll it with fresh water up to the MAX level.
Note: Before starting a descaling cycle make sure that:
1. THE WATER FILTER HAS BEEN REMOVED
2. You have a container of adequate size at hand to be placed in the points identi ed.
To Next Page
Loading...
