Why is the coffee from my Saeco Incanto HD8918 watery or has too little crema?
If the coffee from your Saeco Coffee Maker is watery or has too little crema, it could be due to the grinder being set too coarse. Adjust the grinder to a finer setting. Alternatively, the coffee blend you are using might not be suitable, so try changing the coffee blend.
What to do if my Saeco Incanto HD8918 does not switch on?
If your Saeco Coffee Maker doesn't switch on, check if the mains cord is correctly inserted. Also, ensure that the main switch is in the 'on' position (I). If the issue persists, try switching the machine off and then on again using the main switch located on the back.
Why my Saeco Coffee Maker does not turn on?
If your Saeco Coffee Maker isn't turning on, ensure it's properly plugged in and that the main switch is in the ON position.
Why the filter cannot be activated and the machine asks for descaling on Saeco Incanto HD8918?
If the filter cannot be activated and the machine asks for descaling on your Saeco Coffee Maker, it means that the series of 8 filter is completed. Descale your machine first as described in the '7.5 Descaling cycle' chapter. Thereafter the filter can be installed as described in the '10.2.1 AquaClean installation' chapter.
Why does the drip tray fill up so quickly in my Saeco Coffee Maker?
It is normal for the drip tray to fill up quickly in your Saeco Coffee Maker. The machine uses water to rinse the internal circuit and brew group, and some of this water flows directly into the drip tray. You can place a cup under the dispensing spout to collect rinsing water.
What to do if I cannot activate the AquaClean filter on my Saeco Incanto HD8918?
If you cannot activate the AquaClean filter and the machine asks for descaling, it may be because you have already replaced the AquaClean filter 8 times. Descale your machine first, then install the AquaClean filter. Remember to always activate the AquaClean filter in the menu, especially when replacing the filter.
Why is the frothed milk too cold from my Saeco Incanto HD8918 Coffee Maker?
If the frothed milk from your Saeco Coffee Maker is too cold, try warming the cups with hot water before frothing the milk.
What does water circuit error mean for Saeco Incanto HD8918?
If your Saeco Coffee Maker displays a water circuit error, it may be due to air in the water circuit. Remove and restore the water tank a couple of times, making sure it is correctly positioned. Also, check that the water tank seat is clean.
What to do if brew group locked and cannot be taken out from Saeco Incanto HD8918?
If the brew group of your Saeco Coffee Maker is locked and cannot be taken out, it may be incorrectly positioned. Close the service door, turn the machine off and back on again. Wait for the 'Ready for brewing' signal, and then try removing the brew group.
Why is my Saeco Incanto HD8918 grinding beans but not brewing coffee?
If your Saeco Coffee Maker is grinding coffee beans but no coffee is coming out, the brew group might be dirty. Clean the brew group as described in the '7.2.1 Weekly brew group cleaning cycle' chapter.
Essential safety instructions, warnings, and cautions to prevent injury or damage when using the machine.
Essential initial procedures: water circuit priming (5.2.1), automatic rinse (5.2.2), and manual rinse (5.2.3) cycles before first use.
Instructions for preparing various coffee-only drinks, including pre-ground coffee and single/double button brewing.
Instructions for preparing drinks that combine milk and coffee, like cappuccino.
Procedures for brewing cappuccino, latte macchiato, and frothed milk.
Detailed steps for using, filling, and cleaning the milk carafe for milk drinks.
Procedures for routine cleaning of the Saeco coffee machine, including daily and weekly tasks.
Procedures for cleaning the milk carafe and its components, including daily, weekly, and monthly tasks.
Steps for weekly cleaning, monthly lubrication, and monthly degreasing of the brew group.
Instructions for performing a descaling cycle to remove mineral deposits, including interruption procedures.
Explanation of red display alarm signals and required actions.
Explanation of warning signals and their corresponding actions.
Information on error codes and situations where the machine is out of service.
A table listing common behaviors, causes, and solutions for machine issues.
Essential safety instructions, warnings, and cautions to prevent injury or damage when using the machine.
Essential initial procedures: water circuit priming (5.2.1), automatic rinse (5.2.2), and manual rinse (5.2.3) cycles before first use.
Instructions for preparing various coffee-only drinks, including pre-ground coffee and single/double button brewing.
Instructions for preparing drinks that combine milk and coffee, like cappuccino.
Procedures for brewing cappuccino, latte macchiato, and frothed milk.
Detailed steps for using, filling, and cleaning the milk carafe for milk drinks.
Procedures for routine cleaning of the Saeco coffee machine, including daily and weekly tasks.
Procedures for cleaning the milk carafe and its components, including daily, weekly, and monthly tasks.
Steps for weekly cleaning, monthly lubrication, and monthly degreasing of the brew group.
Instructions for performing a descaling cycle to remove mineral deposits, including interruption procedures.
Explanation of red display alarm signals and required actions.
Explanation of warning signals and their corresponding actions.
Information on error codes and situations where the machine is out of service.
A table listing common behaviors, causes, and solutions for machine issues.
General| Brand | Saeco |
|---|---|
| Model | Incanto HD8918 |
| Category | Coffee Maker |
| Language | English |
To Next Page
