Safety 1st ADJUST N GO User Manual

Harness: Shoulder straps are attached to a splitter plate behind seat. Pull
strap end in front of seat to tighten harness. Push lever at lower front of seat
and pull on shoulder straps to loosen. Lap straps are threaded through slots
at hips and run straight across under seat shell.
Harness slots: There are two sets of slots. To adjust harness for smaller
infant, route straps through lowest set of slots, below metal bar (diagram 1).
To use the lower set of harness slots, you must adjust headrest to lowest
position, you must use upper set of loops on harness positioned as shown
in diagram 2, you must use body pillow (diagram 3), and you must adjust
crotch strap to innermost position with crotch strap anchor on top of shell’s
middle slot (diagram 4). Route harness straps and crotch strap through slots in
body pillow. When using upper set of harness slots, harness straps must be
routed over metal bar (diagram 5). Harness may be raised or lowered by
rotating both adjustment levers inward and lifting or lowering headrest
(diagram 6). Make sure the headrest and metal bar at rear of seat are locked
into position.
Crotch strap: There are three positions. Middle or innermost slot must
be used if child is rear-facing. Any slot may be used for forward-facing.
To change position, turn metal anchor under seat sideways and feed it
through slot to top of seat. Re-thread through desired slot and tug to be sure
anchor is flat underneath seat. If using harness slots below metal bar, crotch
strap must be routed as described in “Harness slots” section above.
SEE PAGE 2
DOREL ADJUST N GO
Type: Convertible/Combination
Last date made: Current
First made: 2020
Weight limits: 5 to 40 lbs. rear-facing, 22 to 50 lbs. & at least
2 years old forward-facing with harness, 40 to 80 lbs. and at
least 4 years old as belt-positioning booster with vehicle lap-
shoulder belt on child.
Harness: 5-point harness to 50 lbs. (removable)
P. 1 of 2
Important: This information sheet is not a substitute for complete manufacturer’s directions and current recall list.
SafetyBeltSafe U.S.A., P.O. Box 553, Altadena CA 91003 (310) 318-5111 (800) 745-SAFE ©SafetyBeltSafe U.S.A. #450 11/21
1
4
2
5
3
6

Safety 1st ADJUST N GO Specifications

General

Brand	Safety 1st
Model	ADJUST N GO
Category	Car Seat
Language	English

Summary

Harness System and Adjustments

Harness Tightening and Loosening

Procedures for adjusting harness tension.

Harness Slot and Crotch Strap Placement

Routing straps through slots and positioning crotch strap.

Car Seat Modes and Installation Basics

Angle Adjustment and Belt Paths

Adjusting recline and routing belts for installation.

LATCH, Tether, and Harness Use

Using LATCH, tether, and harness systems.

Product Overview and Navigation

Quick Navigation Guide

Overview of key tasks and corresponding page numbers.

Car Seat Components

Parts Identification and Harness Detail

Visual guide to parts and harness system.

Accessory Use

Body Pillow and Cup Holder Instructions

Instructions for using accessories.

Choosing Car Seat Mode

Mode Requirements and Limits

Weight, height, and age for each mode.

Preparing Car Seat for Child Fit

Harness Adjustment and Fitting

Steps to adjust harness and fit child.

Child Fit Requirements

Rear-Facing and Forward-Facing Fit

Head, harness, and buckle positioning for modes.

Adjusting Seat Features

Headrest/Harness Height and Buckle Position

Adjusting headrest, harness height, and buckle slots.

Buckle Position Adjustment Steps

Buckle Retainer Manipulation

Detailed steps for adjusting buckle position.

Infant Harness Adjustments

Buckle and Harness Strap Adjustments for Infants

Adjustments for infants using specific slots.

Infant Harness Strap Routing

Harness Strap Routing with Body Pillow

Threading harness straps through lower slots with body pillow.

Seat Recline and LATCH System

Reclining and LATCH Usage

Reclining positions and general LATCH usage.

LATCH and Vehicle Belt Management

LATCH Belt Storage and Vehicle Belt Overview

Managing LATCH belts and introducing vehicle belt install.

Vehicle Belt Retractor Types

Understanding Retractor Types

Explains switchable, automatic, and emergency retractors.

Latch Plate and Tether Safety

Latch Plate Check and Tether Use

Verifying latch plates and using tether forward-facing.

Rear-Facing Installation

Tether Strap Storage and Adjustment

Storing and adjusting the tether strap.

Rear-Facing Vehicle Belt Installation

Pre-Installation Checks and Belt Path

Checks, belt path, and compatibility.

Finalizing Rear-Facing Vehicle Belt Installation

Routing, Buckling, and Tightening Belt

Securing the vehicle belt.

Rear-Facing LATCH Installation

LATCH Belt Routing and Storage

Routing and managing the LATCH belt.

Completing Rear-Facing LATCH Installation

Routing LATCH Belt and Checking Recline

Securing LATCH belt and checking recline.

Finalizing Rear-Facing LATCH Installation

Tightening, Checking, and Finalizing LATCH

Securing and checking LATCH belt and recline.

Forward-Facing Mode and Installation Basics

Mode Requirements and Belt/Tether Install Prep

Mode limits and preparing for installation.

Forward-Facing Vehicle Belt & Tether Installation

Tether Attachment and Belt Routing

Connecting tether and routing vehicle belt.

Finalizing Forward-Facing Belt & Tether Installation

Checking Belt Tightness and Securing Child

Ensuring belt tightness and securing child.

Forward-Facing LATCH & Tether Installation

LATCH Belt Routing and Tether Attachment

Securing LATCH belt and attaching tether.

Finalizing Forward-Facing LATCH & Tether Installation

Attaching LATCH Hooks and Checking Tightness

Connecting hooks and checking belt tightness.

Securing Child in Car Seat

Harness Buckling, Chest Clip, and Tightening

Buckling harness, chest clip, and tightening.

Removing Child and Booster Mode

Steps to Remove Child and Booster Mode Requirements

Removing child and booster mode limits.

Storing Harness System for Booster Mode

Harness Storage Procedures

Steps for storing harness components.

Completing Harness System Storage

Pad Removal and Harness Component Securing

Detaching pads and securing harness.

Booster Seat Fit and Belt Use

Booster Seat Fit Guidelines and Belt Installation

Fit requirements and belt routing for booster mode.

Finalizing Booster Seat Belt Use

Buckling and Positioning Shoulder Belt

Securing and positioning the shoulder belt.

Removing Seat Pad for Cleaning

Initial Pad Removal Steps

Unbuckling harness and adjusting headrest.

Completing Seat Pad Removal

Detaching Headrest and Seat Pads

Removing pads from the car seat shell.

Installing Seat Pad Set

Adjusting Headrest and Fitting Pads

Positioning pads onto the headrest and seat.

Completing Seat Pad Installation

Wrapping and Fastening Seat Pad

Final steps to secure the seat pad.

Installing Harness System

Reclining Seat and Buckle Insertion/Check

Preparing seat and checking buckle security.

Completing Harness System Installation

Harness Strap Threading and Adjustment

Removing and re-threading harness straps.

Aircraft Information

Aircraft Use and Installation Guidelines

Guidelines for using the restraint on aircraft.

Car Seat Replacement and Expiration

Replacement Criteria and Expiration Date

When to replace and expiration date.

Important Safety Guidelines

Child Restraint Use and Installation Safety

General safety warnings for usage and installation.

Vehicle Seating and Registration

Vehicle Seating Position Guidelines

Recommendations for safe seating positions.

Product Warranty

Warranty Terms and Limitations

Details of the product warranty and its limitations.

Troubleshooting Common Issues

Stuck Buckle/Lever and Harness Twisting

Solutions for stuck levers and harness twisting.

Parts and Support Information

Replacement Parts and Customer Support

Parts list and contact information.