To Next PageTo Next Page
Need help?Do you have a question about the Safety 1st MultiFit ARB and is the answer not in the manual?
Crucial safety alert regarding instructions and potential consequences of failure to comply.
Stresses the importance of measuring child's weight and height to select the correct mode.
Specifies weight, height, and age limits for rear-facing mode.
Outlines weight, height, and age limits for forward-facing mode.
Provides weight and height limits for using the seat in booster mode.
Guides on positioning the child and checking for a proper harness fit.
Specifies head position relative to the headrest for forward-facing safety.
Details correct harness strap placement relative to the child's shoulders.
Explains correct buckle slot selection and placement for forward-facing.
Step-by-step guide to fully loosen the car seat's harness straps.
Details methods to adjust the headrest and harness height based on child's growth.
Details using the 1st buckle slot and body pillow for smaller infants.
Instructs to adjust the headrest to the lowest possible position for infants.
Crucial warnings against using UAS belt and vehicle belt simultaneously.
Lists belt types that must not be used with this child restraint.
Emphasizes the critical importance of anchoring the tether strap for safety.
Specifies weight and height limits for rear-facing mode.
Warns against rear-facing installation in a front seat with an active frontal airbag.
Mandates the use of the anti-rebound bar in rear-facing mode.
Instructs to install the anti-rebound bar for rear-facing UAS mode.
Details how to firmly push down and tighten the UAS belt.
Explains how to check for proper belt tightness using the 2.5 cm (1 in.) movement rule.
Specifies weight, height, and age limits for forward-facing mode.
States vehicle belt must be used for installation if child weighs over 18 kg (40 lb).
States minimum age and weight for forward-facing use.
Prohibits UAS anchor use for children over 18 kg (40 lb).
Instructs to remove the anti-rebound bar for forward-facing mode.
Details how to firmly push down and tighten the UAS belt.
Explains how to push down on the seat and pull the tether strap to create tension.
Explains how to check for proper belt tightness using the 2.5 cm (1 in.) movement rule.
Guides on pulling the harness adjustment strap to tighten the harness snugly.
Explains how to check harness tightness by pinching the straps.
Specifies weight and height limits for booster seat mode.
Prohibits using the car seat's harness system in booster mode.
Details correct positioning of lap and shoulder belts across the child.
Prohibits using the UAS with the booster seat.
Instructs to remove the anti-rebound bar for booster seat mode.
Step-by-step guide to fully loosen the car seat's harness straps.
Specifies that child's ears should never be above the headrest.
States child's head must be at least 5 inches below the car's roof.
Details correct shoulder belt placement across the child's shoulder and chest.
Details correct lap belt placement across the child's hips.
Details routing the lap belt portion through the booster belt path.
Details threading the shoulder belt through the headrest guide.
Emphasizes prioritizing child safety and following recommendations.
Details criteria for determining if a car seat needs replacement after a minor crash.
Mandates replacement of the car seat after moderate to severe crashes.
Advises against using the restraint more than 10 years after the manufacture date.
Prohibits removing a child from the restraint while the vehicle is in motion.
Warns against leaving a child unattended in the car seat.
Prohibits using the restraint with damaged or missing parts.
Forbids substituting or modifying parts of the restraint.
States that only accessories approved by Dorel Juvenile Group should be used.
Advises against removing or covering any labels on the child restraint.
Prohibits rear-facing placement in a seating position with an active frontal airbag.
General| Category | Car Seat |
|---|---|
| Brand | Safety 1st |
| Model | MultiFit ARB |
| Type | Convertible Car Seat |
| Weight Limit | 5 - 65 lbs |
| Forward-facing weight capacity | 22-65 lbs |
| Forward-facing height capacity | 29-49 inches |
| Rear-facing weight capacity | 5-40 lbs |
| Rear-facing height capacity | 19-40 inches |
| Safety Features | Side Impact Protection, Anti-Rebound Bar |
| Recline Positions | Multiple |
| Recline Positions Count | 3 |
| Harness System | 5-point harness |
| LATCH Compatible | Yes |
| Installation | LATCH or seat belt |
| Car Seat Weight | 19.5 lbs |
| Weight | 19.5 lbs |
| Height Limit | 19-52 inches |
