Safety 1st MultiFit ARB - Tightening and Adjusting Child Harness; Tightening the Harness; Positioning the Chest Clip; Checking Harness Tightness

continued on next page
6867
Insert Buckle’s Metal Retainer
into Slot Closest to Child
Buckle must face out.
Rear-Facing Mode: You must use
the 1st or 2nd buckle slots.
Forward-Facing Mode: Any slot
can be used.
Fully Recline the Child
Restraint
Pull out on recline handle and
push top of child restraint back.
Check Buckle
Pull up on buckle to make sure it
is secured.
The buckle must not pull out.
Reach Under Seat Between
Base and Shell and Through
Recline Handle
Pull metal retainer completely
through pad and shell.
1
2
3
sewn
end
Coutures à
l'extrémité
1
1
2
3
sewn
end
Coutures à
l'extrémité
3
1
2
3
sewn
end
Coutures à
l'extrémité
2
1
2
3
sewn
end
Coutures à
l'extrémité
4
Installing Harness System
Starting at Top of Seat, Slip
Pad on Shell
5
Wrap Around Bottom and
Sides of Shell
Pull harness adjustment strap
through slot in pad.
7
Push Harness Holders
Through Slots in Pad
6
Attach Fasteners
8
4
Slide Harness Straps into
Slots in Pad and Attach Fas-
teners