Safety 1st Continuum - Cleaning and Pad Replacement; Removing Seat Pad and Cup Holder; Cleaning Instructions

20
WARNINGS: Do not use child restraint without the
seat pad. Failure to do this can result in serious injury or
death.
Cleaning Pad and Accessories
Machine wash all pieces separately with cold water on a gentle
cycle. Do not use bleach. Tumble dry separately for 10-12 minutes
on low heat. Remove immediately.
The cup holder is dishwasher safe.
Cleaning Harness Strap
Spot clean using warm sudsy water and damp cloth.
Replacing Pad
Adjust the headrest to the highest position. Starting from the bot-
tom, gently pull headrest pad onto headrest. Place elastic straps
on headrest pad around headrest/harness adjustment levers. Slide
harness straps into slots in pad. Attach fasteners.
Starting from bottom of child restraint, slip pad on shell. Pull har-
ness adjustment strap through pad. Wrap pad around bottom and
sides of shell. Push harness holders through slots in pad. Push
pad behind headrest. Wrap around the top of shell. Slide harness
straps into slots in pad. Attach fasteners. Attach elastic straps.
Attach cup holder.
5. Pull Headrest Pad Off
Bottom of Headrest
As Shown
Remove headrest pad from shell.
7. Remove Cup Holder
See page 24.
6. Undo Fasteners on Seat
Pad As Shown
8. Release Elastic Straps
from Tabs on the Sides
of the Shell
Repeat for other side.
9. Pull the Pad Off the
Bottom of the Shell
10. Pull Pad Down and
Off Bottom of
Harness Holders
Pull up to remove completely.
11. From the Top, Pull Pad
Off of Shell
19
4358-6840 Continuum.indd 25-264358-6840 Continuum.indd 25-26 10/16/15 2:46 PM10/16/15 2:46 PM