How Does Your Child Fit? Changing Position of Buckle
65
2. Fully Recline the Child
Restraint
Pull out on recline handle and push
top of child restraint back.
1. Unbuckle Harness
Press in towards the top of the red
button.
Pull buckle tongues out.
3. Locate Buckle’s Metal
Retainer
Reach under the seat between the
base and shell and through the
recline handle.
4. Rotate Metal Retainer
and Push It Up Through
Shell and Pad
REAR FACING
FORWARD FACING
Start in the 1st slot and adjust outward as your
child grows. Buckle should be used in the slot
closest to your child. The buckle should not be
underneath or behind your child. 1st or 2nd slot
MUST be used.
Always choose the shoulder harness slots that
are closest to your child’s shoulder height.
Harness strap MUST be at or slightly below
shoulders.
If the lower shoulder harness slots for smaller
infants are above the child’s shoulders with the headrest in the
lowest position, do not use this child restraint.
Start in the 1st slot and adjust outward as your
child grows. Buckle should be used in the slot
closest to your child. The buckle should not be
underneath or behind your child. Any slot can be
used.
Always choose the shoulder harness slots that
are closest to your child’s shoulder height.
Harness strap MUST be at or slightly above
shoulders.
If the upper shoulder harness slots are below the
child’s shoulders with the headrest in the highest
position and the child weighs at least 40 lb (18 kg) and is at least
4 years old, you must convert the child restraint to a booster seat.
To change buckle position, see pages 6-7.
To adjust headrest/harness height, see page 8.
To make adjustments for smaller infants, see pages 9-11.
Use the guidelines below to determine if the buckle and harness
strap are in the right place for your child.
continued on next page
4358-6840 Continuum.indd 11-124358-6840 Continuum.indd 11-12 10/16/15 2:46 PM10/16/15 2:46 PM
To Next Page
Loading...