WARNINGS: Do not use LATCH belt
along with the vehicle lap or lap/
shoulder belt. Secure LATCH to storage
attachments as shown when installing
with vehicle belts.
Secure the tether hook when used rear
facing. Attach the tether hook to
storage attachment as shown and
gently tighten to remove slack.
Check vehicle belt before each use.
Use only if the belt can be tightened
properly and locked securely in place.
Failure to follow these warnings can
result in serious injury or death.
Vehicle Belt Installation
38
To Release LATCH
Remove child from child restraint.
Remove tension from LATCH belt
by pushing down on side of child
restraint with LATCH adjuster. Then
press adjuster button to loosen belt.
Unhook LATCH from bar by squeezing
spring lever, pushing hook back into
the seat bight and twisting. Then pull
it out of the vehicle seat.
Store LATCH when not in use. See
page 28.
37
continued on next page
Safety Tips
Make sure harness and buckle fit your child correctly before
installing the child restraint. See pages 3-5.
Experts agree that children should remain rear facing as long
as possible. In this child restraint, your child can remain rear
facing up to 40 lb (18 kg) and up to 40 in. (101.6 cm).
1. Fully Recline the Child
Restraint
Pull out on recline handle and push
top of child restraint back.
4358-6840 Continuum.indd 43-444358-6840 Continuum.indd 43-44 10/16/15 2:47 PM10/16/15 2:47 PM
To Next Page
Loading...