Why Sage Smart Grinder Pro SCG820 Coffee Grinder won't start?
Your Sage Coffee Grinder might not start due to several reasons: it may not be plugged into the power outlet, it may have overheated, or the bean hopper may not be correctly attached. Ensure the power cord is plugged in, allow the grinder to cool down for 20 minutes if overheated, and lock the bean hopper into position.
What to do if Sage Smart Grinder Pro SCG820 motor starts but no coffee comes out?
If your Sage Coffee Grinder's motor runs but no ground coffee is coming out, check the following: Ensure you've pressed the START / PAUSE / CANCEL button or PORTAFILTER SWITCH to activate it. Also, make sure the bean hopper has coffee beans. Finally, inspect the bean hopper and burrs for any blockages.
How to adjust the amount of coffee grind in Sage Coffee Grinder?
To adjust the amount of coffee grind in your Sage Coffee Grinder, press the SHOTS / CUPS button to change the grind amount. You can also use the Grind Amount Dial to fine-tune the amount, choosing ‘more’ or ‘less’ as needed.
Why is my Sage Coffee Grinder making a loud noise?
A loud racket noise from your Sage Coffee Grinder could be due to a foreign item blocking the grinder or moisture clogging it. Remove the bean hopper and inspect the burrs for any foreign objects. Clean the burrs and chute, let them dry thoroughly, or use a hair dryer to blow air into the grinder inlet to dry it.
How to lock the bean hopper on Sage Smart Grinder Pro SCG820 Coffee Grinder?
If you're unable to lock the bean hopper into position on your Sage Coffee Grinder, it might be due to coffee beans obstructing the locking device. Remove the bean hopper, clear any coffee beans from the top of the burrs, and then try to re-lock the hopper into position.
Why is the portafilter overflowing with coffee from my Sage Smart Grinder Pro SCG820?
It is normal for the correct amount of coffee to appear overfilled in your portafilter because untamped coffee has approximately three times the volume of tamped coffee.
General| Grind Settings | 60 |
|---|---|
| Display | LCD |
| Material | Plastic and Stainless Steel |
| Voltage | 220-240V |
| Construction Materials | Plastic and Stainless Steel |
| Burr Type | Conical Burr |
| Dose Control | Yes |
| Frequency | 50-60Hz |
| Type | Burr Grinder |
| Dimensions Variation 1 | Not applicable |
| Dimensions Variation 2 | Not applicable |
| Dimensions Variation 3 | Not applicable |
| Weight Variation 1 | Not applicable |
| Weight Variation 2 | Not applicable |
| Bean Hopper Capacity | 450g |
| Power | 165 watts |
To Next Page
