S
S
E
E
T
T
T
T
I
I
N
N
G
G
U
U
P
P
H
H
O
O
S
S
T
T
C
C
O
O
M
M
M
M
U
U
N
N
I
I
C
C
A
A
T
T
I
I
O
O
N
N
.
.
Communication mode
/cfg/Maccess/Admin/Host Com
0 Stand alone
1 Connected through COM1
2 Connected through COM2
3 Connected through ETHERNET
This parameter allows management of a local database within the
MorphoAccess™ using a remote station or with local facilities.
FILE : cfg/Maccess
SECTION :Admin
Host Com : 3
PREV NEXT EXIT EDIT
The default value of Host Com key is 3 (MEMS). In this case, the biometric
management is between terminal and MorphoAccess™ Enrollment
Management System (MEMS).
To configure the MorphoAccess™ terminal to manage the local database,
this default value must be changed to 0.
COM1 or COM2 mean serial link administration.
You cannot use the stand-alone mode to manage your local database if
the MorphoAccess™ biometric data is managed by the MEMS.
The MorphoAccess™ shall be used either in stand-alone mode or in
connected mode (with MEMS) but never in both modes.
Configuring the key to 0 will disable MEMS connection.
For more information about commands accepted by the terminal please
refer to MorphoAccess™ Host System Interface.
60
SAGEM Défense Sécurité document. Reproduction and disclosure forbidden. SK-0000011145-05
To Next Page
Loading...