What to do if my Sailfish 272 CC fails to operate?
If your Sailfish Boat fails to operate, it could be due to a few reasons. The battery isolation might be OFF, the breaker could be tripped, or a fuse might have blown. If no voltage is present, check the battery. Another potential cause is a defective control switch. Check the voltage at the output terminals of the control switch with the switch on forward then reverse.
Why is my Sailfish 272 CC Boat windlass operating sluggishly?
If your Sailfish Boat's operation is sluggish, it could be due to several reasons. First, the windlass might be overloaded, in which case you should ease the load and ensure the battery is well charged. Second, there could be a severe voltage drop in the circuit; check for undersized, poor, or corroded connections, and also check for resistance across the battery isolation switch or solenoid. Finally, the motor might be defective, requiring replacement.
How to stop Sailfish 272 CC Boat anchor rode paying out independently?
To stop the anchor rode from paying out independently on your Sailfish Boat when the windlass isn't in use, tighten the Gypsy Drive Cap using the provided tool. Always secure the anchor rode independently of the windlass whenever it is not being deployed or recovered.
Overview of key physical and performance specifications for the boat.
Lists standard equipment and components for the boat.
Lists optional equipment and features available for the boat.
Identifies the physical locations of safety and warning labels on the boat.
Provides contact information for obtaining replacement safety and warning labels.
Illustrates and describes the front view of the battery selector panel.
Details breaker, switch, distribution, deck, and hard top harness wiring.
Describes the UFLEX hydraulic steering system used with Mercury engines.
Explains the features and benefits of the Yamaha Helm Master EX steering system.
Explains the use and benefits of Deutsch Connectors for wiring systems.
Describes the function and location of the fuel-water separator filters.
Describes how to access the bilge area and its importance for checking.
Details the types of bilge pumps used and their testing procedures.
Explains the operation and access to the raw water washdown system.
Describes the freshwater washdown and shower system and tank location.
Provides instructions on how to operate the boat's livewell system.
Details the fishbox pump (gulper grouper) and troubleshooting steps.
Provides maintenance recommendations and troubleshooting for the windlass.
Offers troubleshooting charts for common issues with the windlass.
Lists common problems, causes, and service instructions for the waste system.
Provides step-by-step cleaning instructions and Do's/Don'ts for vinyl surfaces.
Explains how to prevent and address cosmetic corrosion (pitting) on aluminum, including tips and products.
Discusses stainless steel properties, care, and potential discoloration.
Provides methods for repairing scratches, gouges, and chips in the gel coat.
General| Length Overall (LOA) | 27' 2" |
|---|---|
| Maximum Horsepower | 400 HP |
| Draft (Hull) | 18 in. |
| Freshwater Capacity | 14 gal |
| Cockpit Area | 82 sq ft |
| Engine Options | Twin |
To Next Page
