Sakura Tissue-Tek Glas User Manual

Coverslipping
Tissue-Tek® Glas™ Coverslipper
Quick Reference Guide
Tissue-Tek® Glas™ Coverslipper
QRG | Glas Coverslipper | 2011 | V-2 page 3 | 6
Installing the nozzle reservoir
1. Set the dispensing tray in the system by
aligning the tray with the two guide rails (only
for the first time use).
Placing Anti-drying Bottle (1) and waste Container (2
Filling anti drying bottle
1. Fill the anti drying bottle with solvent to just
below the lid.
Note: type of solvent depends on the mounting medium
2. Place the anti-drying bottle and waste
container in the dispensing tray.
Handling the dispensing nozzle
1. When setting the anti-drying bottle, push down
the dispensing nozzle in a backward direction
and then set the bottle.
2. After the anti-drying bottle and waste container
have been set, lift the dispensing nozzle and
return the nozzle so that its tip enters the hole
in the anti-drying bottle. (see description
“handling the dispensing nozzle”).
Handling dispensing nozzle Filling anti-drying bottle
Filling “pump anti drying bottle”
1. Remove the lid and add solvent for mounting
medium into the pump reservoir.
Note: type of solvent depends on the mounting medium.
2. Fill the pump anti drying bottle with solvent to
just below the lid.
Filling pump anti drying bottle
Filling loading station
1. Fill the loading station with solvent until the
specified level.
Note: type of solvent depends on the mounting medium.
Filling loading Station
Required level
Required level
1
2

Sakura Tissue-Tek Glas Specifications

General

Brand	Sakura
Model	Tissue-Tek Glas
Category	Laboratory Equipment
Language	English