OWNER’S MANUAL V.052021 ENGLISH
M-065 INDOOR BIKE K5
This manual can be downloaded on www.salter.es
App training
If you want to send your real-time training data to the compatible sport APPs, once the console is ON,
kindly briefly press the middle button (“ENTER”) in order to open it to send data. This one will beep and, at
the sceen, a number and a blinking “BT” word will appear. At that time, kindly turn your device’s
Bluetooth® (and GPS in case this one is Android), open one compatible APP and, while you are setting the
sensors, look for the console’s screen number to set it as another sensor. If everything is correct, console’s
feedback will hide and you will be able to get all the feedback at your mobile device.
6. INSTRUCTIONS OF USE
Intensity adjustment: use the knob to adjust the
intensity of the workout. For emergency stop then push
control lever up-ward to the hardest position for
stopping the wheel.
Handlebar and seat adjustment. It is important that
the handlebar and seat are set at the height correct for
your body. Ask your instructor for assistance.
- Adjusting the handlebar height: Make sure it is
securely tightened and that there is no lateral or
vertical movement of the handlebar. Undo the Quick
Release lever which is located in front of main tube.
Slide stem tube in upward or downward to the required
height position then re-tighten again.
- Adjusting the seat height: Make sure it is securely tightened and that there is no lateral or vertical
movement of the handlebar. Undo the Quick Release lever which is located in front of main tube.
Slide stem tube in upward or downward to the required height position then re-tighten again.
- The stem/sliding tube position can also be adjusted forwards or backwards. Undo the Quick
Release lever located underneath of the bottom of sliding tube. Slide the handlebar/top sliding
tube in forwards or backwards until reach the required position then securely re-tighten the
Quick Release lever.
NOTE: there is a safety line engraved on the seat post and handlebar stem ever be raised above this line.
Pedals and toe straps . Your feet should be securely positioned in the toe clips during the exercise.
Put your foot as far forward as you can into the toe-clip and then pull the strap tight.
NOTE: Bike should operate on a level surface with no lateral movement.
There are height adjust pads located on either side underneath of front and rear ground tube.