Salton FC2074 - Delayed Brew Function

5. Press the ON/OFF Button and the On Indicator Light will illuminate
and the brew cycle will start. (To use the delay start function follow
the directions in the “Delayed Brew Cycle section” below)
NOTE: The brew cycle can be interrupted by pressing the ON/OFF
Button at any time. Hot water which has already entered the Filter
will continue to drip until the Filter is empty so long as the Carafe
remains in position. If you press the ON/OFF button again the brew
cycle will continue.
6. In a few minutes the coee will be brewed, and the Coee Maker
will automatically switch over to ‘Keep Warm’ mode for the next
two hours. The ‘Keep Warm Cycle’ will shut o automatically and
the ON Indicator Light will go out at the end of the 2 hours. NOTE:
The keep warm time will be shown on the Display as soon as the
brewing cycle has ended. The clock will not appear during this time.
Once the keep warm cycle has ended, the clock will appear on the
Display. If you wish to turn o the Coee Maker before 2 hours has
elapsed, press the ON/OFF Button once.
7. See the ‘Pause & Serve’ section to pour a cup of coee before the
brew cycle ends.
8. Always turn o the Coee Maker and unplug from the wall outlet
when not in use.
Delayed Brewing
1. Fill the Water Reservoir with fresh cold water for the desired number
of cups. Fill the Water Reservoir by rst lling the Carafe and then
pouring water into the Water Reservoir.
NOTE: Do not ll above the maximum Water Line (10) or less than
the minimum Water Line (4) indicated on the Carafe and Water
Reservoir.
2. Remove the Reusable Filter and ll with the desired amount of
ground coee.
NOTE: Use coee that is ground specically for automatic drip
coee makers. Usually one Coee Measuring Scoop or a level
tablespoon of ground coee is used for each cup of coee. Adjust
the amount to your personal taste.
3. Reposition the Reusable Filter and close the Lid.
NOTE: If the Lid does not close completely, ensure that the Filter
Holder and Reusable Filter are properly seated in position.
4. Place the Carafe with Lid on the Keep Warm Plate. NOTE: To use
the Bold Setting function, hold the PROG button for 3 seconds.
The Bold Setting Indicator (two coee beans), will illuminate in the
bottom right of the Display when this setting is engaged. To turn o
this setting, hold the PROG button for 3 seconds.
5