To Next PageTo Next Page
Need help?Do you have a question about the Salus RXWBC605 and is the answer not in the manual?
General| Brand | Salus |
|---|---|
| Model | RXWBC605 |
| Category | Thermostat |
| Language | English |
Lists compliance with essential EC Directives including EMC, Low Voltage, and EC Marking.
Applicable to Salus Controls models, fitting by competent persons, adherence to UK wiring regulations.
Highlights LED status indication, ON/OFF switch, and 868 MHz communication for the RXRT505.
Guidance on suitable mounting locations, power requirements, and protection from environmental factors.
Details terminal identification (NO, COM, L, N) and their respective functions for wiring.
Illustrates connection of the receiver to the boiler's external loop and mains power supply.
Instructions for automatic pairing and adjusting RF address codes via DIP switches or jumper caps.
Procedure for pairing S-Series thermostats, including entering the Pair Menu on the thermostat.
Lists features such as LED status, manual override capability, and 868 MHz communication.
Guidance on suitable mounting, power requirements, and protection from moisture for the RXST625.
Details terminal functions (COM, NO, Earth, L, N) and wiring for the RXST625 receiver.
Steps for pairing the RXST625 using slide switches and the SYNC button for RF synchronization.
Explains various LED states (Blue, Green, Red, Yellow) and their corresponding system indications.
Lists key operations like Auto, Manual, On, Cycle, Off, SYNC, and Reset buttons with their functions.
Details the AUTO mode operation and behavior when RF communication is lost.
Describes manual operation where the receiver ignores RF signals and relies on failsafe settings.
Details the selectable failsafe modes (ON, CYCLE, OFF) and their LED indicators.
Introduces the RXVBC605 as a plug-in RF boiler control unit for thermostats.
Highlights LED status, plug-in connection, 3-position switch, and 868 MHz communication.
Critical safety advice regarding electrical components, power isolation, and ESD precautions.
Step-by-step guide for boiler control installation, including panel removal and connection.
Instructions for setting the module switch to OFF, ON for testing, and then AUTO.
Steps for pairing the RXVBC605 by setting the module to AUTO and using the SYNC button.
Details the function of the LED (A), Mode Switch (B), and SYNC Button (C).
Introduces the RXWBC605 as a plug-in RF boiler control unit for thermostats.
Highlights LED status, plug-in connection, 3-position switch, and 868 MHz communication.
Discusses RF receiving range, factors affecting it, and typical operating distances.
Critical safety advice regarding electrical components, power isolation, and ESD precautions.
Steps for preparing the boiler for control installation, including casing and fascia removal.
Guide on plugging in the connector block and securing the cover panel for the boiler control.
Instructions for setting the module switch to OFF, ON for testing, and then AUTO.
Details AUTO, MANUAL ON, and OFF modes for the RF boiler control and their LED indications.
Explains the function of the LED (A), Mode Switch (B), and SYNC Button (C).
Steps for pairing the RXWBC605 by setting the module to AUTO and using the SYNC button.
Details RF settings, operating frequency, range, and environmental conditions for RXRT505.
Lists model, type, power supply, switching, RF settings, and protection rating for RXST625.
Details RF settings, operating frequency, range, and environmental conditions for RXVBC605.
Details RF settings, operating frequency, range, and environmental conditions for RXWBC605.
Details the two-year warranty period and Salus Controls' liability for product defects.
