Salus VS10WRF - Calibration Procedure; Adaptive Learning Mode

53 VS20WRF and VS20BRF Installer Manual
Adaptive Learning Mode will start automatically. When Adaptive Learning Mode is
active the thermostat will show on the bottom of the device and will warm
your radiators up slightly. This is perfectly normal. If you would rather not use this
feature you can disable it.
Adaptive Learning Mode is a new feature that will make minor adjustments in the
rst few days after installation to ensure you get the best combination of comfort and
eciency from your SALUS SmartHome product.
For systems without the SALUS RX10RF boiler receiver
For systems with the SALUS RX10RF boiler receiver
Adaptive Learning Mode is disabled and standard on/o control is used. If selected,
your boiler will be on for short periods occasionally over the rst few days. This is
perfectly normal.
Note: Once the system has fully learned then the thermostat will start only
when required.
Calibration Procedure