• Make sure the lever is open and guide the front wheel carefully onto the axle and brake
caliper. Fully seat the skewer in the fork dropouts (and the brake rotor in the caliper) and
add tension to the lever by turning the thumbnut. When there is enough resistance to
hold the quick release lever in line with the axle, close the lever using the palm of your
hand without touching the brake rotor.
• When properly installed, the front wheel should be fully seated and centered in the
dropouts of the front fork, the brake rotor should be in between the brake pads in the
brake caliper, and the quick release lever should be fully and properly secured. Ensure
the front wheel and quick release lever are properly secured.
7
To Next Page
Loading...