SAMLEX AMERICA INC. | 11
3.4.1.1 Entering Standby Mode Using Remote Control EVO-RC-PLUS: Changing over from any
Operating Mode (“Inverting”, “Charging” or “Power Save”) to Standby Mode can be carried out with the help
of Remote-Control EVO-RC-PLUS as follows:
a) From any Operating Mode Screen (“Inverting”, “Charging” or “Power Save”), press the On/Off Key (2, Fig 1.1)
momentarily (0.1 sec)
b) Screen shown below will be displayed for 5 sec and then, the screen will go back to the Operating Mode
Screen.
G o t o S t a n d b y ?
Y e s = O n / O f f k e y
N o = B a c k k e y
• If Standby Mode is required to be activated, press the On/Off Key (2, Fig 1.1) momentarily (0.1 sec)
• If Standby Mode is not required to be activated, press the Back Key (5, Fig 1.1) momentarily (0.1 sec)
c) On entering Standby Mode, the following will be displayed:
i. On the EVO-RC-PLUS:
a. For EVO-1212F/1212F-HW/1224F/1224F-HW:
o The LCD will show the 1st Screen (Screen 1) of the 7 Standby Mode Screens [See Fig 3.1(a)]
E V O - 1 2 1 2 F S t a n d b y
A C o u t p u t : 0 . 0 V
< 0 . 1 A
0 . 0 0 H z
o Blue LED marked “Status” (3, Fig 1.1) will blink once every 5 sec
b. For EVO-3012/2212/2224/4024:
o The LCD will show the 1st screen (Screen 1) of the 7 Standby Mode Screens for EVO-
3012/2212.2224/4024 [see at Fig 3.1(b)]
E V O - 3 0 1 2 S t a n d b y
A C o u t p u t : 0 . 0 V
< 0 . 1 A
0 . 0 0 H z
o Blue LED marked “Status” (3, Fig 1.1) will blink once every 5 sec
ii. On the Front Panel of EVO Inverter-Charger:
The Blue LED marked “ON” (12, Fig 2.1 of the EVO Inverter-
Charger Manual) will blink once every 5 sec. Red LED marked “FAULT” (13, Fig 2.1 of EVO Inverter Charger
Manual) and Buzzer will be off
3.4.1.2 Exiting Standby Mode:
o Using EVO-RC-PLUS: To exit Standby Mode using EVO-RC-PLUS, press the On/Off Key (2, Fig 1.1)
momentarily (0.1 sec).
o From Front Panel of EVO Inverter Charger Unit: To exit Standby Mode from the EVO unit, momentarily (0.1
sec) press the On/Off Push Button on the front panel of the EVO (11, Fig 2.1 of the EVO Inverter-Charger
Manual)
INFO
Please note that when Standby Mode is exited, EVO Inverter-Charger Unit will execute the programmed
Operating Mode from the beginning. It will NOT start from the last condition of the operating stage it was in
when Standby Mode was activated
SECTION 3 | Operation
To Next Page
Loading...