SAMLEX AMERICA INC. | 39
4.3.2 Disabling Password Protection
In the default / factory preset condition, Password Protection is enabled.
Password Protection may be disabled, if required.
Procedure is given below:
1. Press ENTER Key momentarily from any Operating Mode Screen (see details at Table 3.1)
S e l e c t G r o u p
* C H A R G E C U R V E
• Screen No. 1 of "Select Group * CHARGE CURVE"
(Fig 4.1) will appear as shown on the left.
2. Press "Down Key" 4 times to scroll to "*OTHER FUNCTION" screen.
S e l e c t G r o u p
* O T H E R F U N C T I O N
• Screen No. 5 of "Select Group * OTHER FUNCTION"
(Fig 4.1) will appear as shown on the left.
3. Press ENTER Key momentarily
S e l e c t G r o u p
O T H E R F U N C T I O N
* P O W E R S A V I N G
0 = D i s a b l e
• Screen No. 1 of "Select Parameter, OTHER FUNCTION,
*POWER SAVING, 0=Disable" (Fig 4.4) will appear as in
the left.
4. Press DOWN Key momentarily, (i) 11 times for EVO-1212F / 1212F-HW / 1224F / 1224F-HW or
(ii) 12 times for EVO-2212 / 3012 / 2224 / 4024
S e l e c t G r o u p
O T H E R F U N C T I O N
* P A S W O R D D I S A B L E
0 = D i s a b l e
• Screen "Select Parameter, OTHER FUNCTION, * PASSWORD DISABLE,
0=Disable" (Fig 4.4) will appear as on the left.
NOTE: Default value is 0=Disable i.e. Disable the command "DISABLE
PASSWORD" which means enable password protection.
5. Press ENTER Key momentarily
P a s w o r d k e y i n
0 0 0 0
• Password consisting of 4 digits "0000" will be requested as shown on
the left. The rst digit will have a blinking cursor
"_"Use Up /Down Keys to scroll to number 8 for the rst digit “8”
of the password. Momentarily press Enter Key (Short press). Digit
8 will be entered as the rst digit of the Password and the blinking
cursor will automatically move to the 2
nd
digit (0) to the right. As the
next digit in the Password “8052” is already “0”, momentarily press
Enter Key (Short press) to enter “0” in the 2
nd
digit. The blinking
cursor will automatically move to the 3
rd
digit (0). Use Up /Down Keys
to scroll to number 5 for the 3
rd
digit “5” of the password “8052” and
momentarily press Enter Key (Short press). The blinking cursor will
automatically move to the 4
th
digit (0). Use Up /Down Keys to scroll to
number 2 for the 4
th
digit “2” of the password “8052”. Now keep the
Enter Key pressed continuously for longer time (3 to 4 sec) to write
the full password of 4 digits i.e. “8052”.
SECTION 4 | Parameter Setup
To Next Page
Loading...
