Samson 3241 User Manual (English)

Other manuals for Samson 3241

Mounting And Operating Instructions102 pages

Questions and Answers:

J
jeremyclarkJul 27, 2025
What to do if increased flow through closed Samson Control Unit valve (seat leakage)?
- O
  Omar CowanJul 27, 2025
  If you observe increased flow through a closed Samson Control Unit valve, it could be due to dirt or foreign particles lodged between the seat and plug. Try shutting off the pipeline section and flushing the valve to remove any debris. Alternatively, the valve trim, especially with a soft seat, might be worn. In this case, you would need to replace the seat and plug.
W
Wesley RobinsonAug 3, 2025
Why does the Samson Control Unit valve leak to the atmosphere (fugitive emissions)?
- S
  Scott FletcherAug 3, 2025
  A Samson Control Unit valve may leak to the atmosphere due to several reasons. It could be caused by defective packing, or if it's a version with adjustable packing, the packing might not be tightened correctly. Another possibility is loose flanged joints or worn-out body gaskets. Check the flanged joints. If the issue persists, replace the gaskets at the flanged joints.
C
Christina DavisAug 11, 2025
What to do if actuator and plug stem does not move on demand in Samson Control Unit?
- D
  Daryl GriffithAug 11, 2025
  If the actuator and plug stem in your Samson Control Unit do not move on demand, first check if the actuator is blocked and remove the blockage. You can put the control valve out of operation. Also, verify the signal pressure and check the signal pressure line for any leakage. If the diaphragm in the actuator is defective, consult the actuator documentation.
C
cindy26Aug 19, 2025
Why actuator and plug stem does not stroke through the full range in Samson Control Unit?
- A
  Amanda JohnsonAug 19, 2025
  If the actuator and plug stem in your Samson Control Unit do not stroke through the full range, this could be due to several reasons. Check the signal pressure and inspect the signal pressure line for leaks. Also, the travel stop might be active. Furthermore, incorrect settings of valve accessories can cause this issue, so check the settings of the valve accessories.