Samson 3244 - Page 21

EB 8026 EN 3-5
Design and principle of operation
Dimensions and weights
Table 3-1 to Table 3-4 provide an overview of the dimensions and weights of the standard
version of Type3244 Valve as well as the version with insulating section or bellows seal. The
lengths and heights in the dimensional drawings are shown on page3-6.
The weights specied apply to a specic standard device conguration. Weights of other
valve congurations may differ depending on the version (material, trim etc.).
The associated actuator documentation applies to actuators, e.g. SAMSON pneumatic actu-
ators:
uT8310-1 for Type3271 or Type3277 Pneumatic Actuators up to 750cm² actuator area
Table 3-1: Dimensions of the standard version of Type3244 Valve (DIN version)
Valve DN 15 20 25 32 40 50 65 80 100 125 150
L mm 130 150 160 180 200 230 290 310 350 400 480
H1 mm 235 270 360 375
H2 mm 70 80 85 100 105 120 130 140 150 200 210
Table 3-2: Dimensions of the standard version of Type3244 Valve (ANSI version)
Valve
DN 15 20 25 40 50 65 80 100 150
NPS ½ ¾ 1 1½ 2 2½ 3 4 6
L
Class150
mm 184 184 184 222 254 276 298 352 451
in 7.25 7.25 7.25 8.75 10.00 10.88 11.75 13.88 17.75
Class300
mm 190 194 197 235 267 292 318 368 473
in 7.50 7.62 7.75 9.25 10.50 11.50 12.50 14.50 18.62
H1
mm 235 270 360 375
in 9.25 10.63 14.17 14.76
H2
Class150
mm 92 92 92 111 127 138 149 176 225.50
in 3.62 3.62 3.62 4.37 5.00 5.43 5.87 6.93 8.88
Class300
mm 95 97 98.50 117.50 133.50 146 159 184 236.50
in 3.76 3.82 3.88 4.63 5.26 5.75 6.26 7.24 9.31
Note