Samson 3251 - Page 25

EB 8052 EN 3-5
Design and principle of operation
Dimensions and weights
The weights specied apply to a specic
standard device conguration. Weights of
other valve congurations may differ de-
pending on the version (material, trim etc.).
Table 3-1 to Table 3-4 provide an overview
of the dimensions and weights of the stan-
dard version of Type3251/3251-AM Valve.
The lengths and heights in the dimensional
drawings are shown on page3-9.
Dimensions in mm · Weights in kg
Table 3-1: Dimensions of Type3251/3251-AM Valve, up to NPS6
= Versions available for Type3251-AM (restricted range for Type3251-AM)
Valve
NPS ½ 1 1½ 2 3 4 6
DN 15 25 40 50 80 100 150
Length L
(anges RF
and weld-
ing ends)
Class150
in 7.25 7.25 8.75 10.00 11.75 13.88 17.75
mm 184 184 222 254 298 352 451
Class300
in 7.50 7.75 9.25 10.50 12.50 14.50 18.62
mm 190 197 235 267 318 368 473
Class600
in 8.00 8.25 9.88 11.25 13.25 15.50 20.00
mm 203 210 251 286 337 394 508
Class900
in 8.50 10.00 12.00 14.50 15.00 18.00 24.00
mm 216 254 305 368 381 457 610
Class1500
in 8.50 10.00 12.00 14.50 18.50 21.61 27.75
mm 216 254 305 368 470 549 705
Class2500
in 10.38 12.12 15.12 17.75 22.75 26.50 36.00
mm 264 308 384 451 578 673 914
Height H4
Class 150
to 600
in 5.98 5.98 6.46 8.54 8.74 9.53 12.36
mm 152 152 164 217 222 242 314
Class900
in 7.32 7.32 7.68 9.88 8.74 9.53 12.36
mm 186 186 195 251 222 242 314
Class 1500
to 2500
in 7.32 7.32 7.68 9.88 11.34 13.7 18.35
mm 186 186 195 251 288 348 466