14-8 EB 8051 EN
Classification: Public · SAMSON AKTIENGESELLSCHAFT · Weismüllerstraße 3 · 60314 Frankfurt am Main, Germany
Declaration of Incorporation in Compliance with Machinery Directive 2006/42/EC
For the following products:
Type 3251/3251-AM Globe Valve
We certify that the Type 3251/3251-AM Globe Valves are partly completed machinery as de-
fined in the Machinery Directive 2006/42/EC and that the safety requirements stipulated in
Annex I, 1.1.2, 1.1.3, 1.1.5, 1.3.2, 1.3.4 and 1.3.7 are observed. The relevant technical doc-
umentation described in Annex VII, part B has been compiled.
Products we supply must not be put into service until the final machinery into which it is to be
incorporated has been declared in conformity with the provisions of the Machinery Directive
2006/42/EC.
Operators are obliged to install the products observing the accepted industry codes and prac-
tices (good engineering practice) as well as the mounting and operating instructions. Opera-
tors must take appropriate precautions to prevent hazards that could be caused by the pro-
cess medium and operating pressure in the valve as well as by the signal pressure and mov-
ing parts.
The permissible limits of application and mounting instructions for the products are specified
in the associated data sheets as well as the mounting and operating instructions; the docu-
ments are available in electronic form on the Internet at www.samsongroup.com.
For product descriptions of the valve, refer to:
- Type 3251/3251-AM Valve (DIN): Mounting and Operating Instructions EB 8051
- Type 3251/3251-AM Valve (ANSI): Mounting and Operating Instructions EB 8052
Referenced technical standards and/or specifications:
- VCI, VDMA, VGB: Leitfaden Maschinenrichtlinie (2006/42/EG) – Bedeutung für Armaturen, May 2018
[German only]
- VCI, VDMA, VGB: Zusatzdokument zum „Leitfaden Maschinenrichtlinie (2006/42/EG) – Bedeutung für
Armaturen“ vom Mai 2018 [German only], based on DIN EN ISO 12100:2011-03
Comments:
- See mounting and operating instructions for residual hazards.
- Also observe the referenced documents listed in the mounting and operating instructions.
Persons authorized to compile the technical file:
SAMSON AG, Weismüllerstraße 3, 60314 Frankfurt am Main, Germany
Frankfurt am Main, 9 January 2024
Stephan Giesen
Director
Product Management
Director
Product Maintenance & Engineered Products
To Next Page
Loading...
