Samson Meteor Mic Owner's Manual

8
Installing the Meteor Mic
3. To set the Meteor Mic as your default device for sound playback and recording, or to change
its settings, click the Start button, click Control Panel and then click Sounds and Audio De-
vices. In the Audio tab, select the Samson Meteor Mic from the drop-down menu.
4. To set the gain of the microphone, click the Volume button in the Sound recording section
to make the Microphone slider appear. It will say “Samson Meteor Mic” in the status bar at
the bottom. Moving this slider will adjust the analog amplier circuitry in the microphone.
5. To set the headphone level, click the Volume button in the Sound playback section, and set
the Speaker slider to the maximum position. Use the Meteor Mic’s front panel Volume knob
to control the overall output from the headphones or speakers.
6. To set the direct monitoring level in the headphones, click the Volume button in the Sound
playback section. Adjusting the Microphone slider changes the microphone monitoring
level, and will not aect the microphone level sent to your software.
Note: If the Microphone section does not appear at rst, click Options and then Properties, and
click the checkbox next to Microphone.

Samson Meteor Mic Specifications

General

Type	Laptop microphone
Bit rate	16 bit
Sample rate	48 kHz
Noise reduction	Yes
Microphone frequency	20 - 0.02 Hz
Microphone direction type	Cardioid
Device interface	USB
Connectivity technology	Wired
Number of products included	1 pc(s)
Product color	Chrome