Meteor Mic · USB Studio Condenser Microphone
13
Acoustic Guitar
There are a variety of ways that the Meteor Mic can be used to mike an acoustic guitar. Optimal
microphone placement will depend on the type of instrument, and what kind of sound you’re
looking to capture. It may be necessary to experiment with
various positions to achieve full and balanced tone. When
miking a standard steel string acoustic, it is suggested that you
begin with the microphone at a distance of 6–12 inches from
the sound hole, positioned slightly o-axis, and pointing to-
wards the edge of the ngerboard. From this position, moving
the microphone towards the sound hole will cause the mic to
capture more low frequencies. If, instead, you wish to capture
more high-end, or to remove any unwanted boominess, move
the microphone toward the ngerboard. Unlike a steel string acoustic guitar, the sound of a nylon
string acoustic guitar that is played by nger picking is usually naturally warmer. To record an
even, full tone, it is suggested that you begin by positioning the microphone 3–6 inches above
the center of the bridge. This will help emphasize the higher frequencies and pick up the attack
sound of the nger picking. If the microphone is picking up too much low frequency from the
sound hole, move the microphone so that it is slightly o-axis from the guitar. If you have a pair of
Recording Techniques
To Next Page
Loading...
Need help?
General
