Need help?Do you have a question about the Samson MXS 2800 and is the answer not in the manual?
General| Power Output | 2800W |
|---|---|
| Channels | 2 |
| Frequency Response | 20Hz-20kHz |
| Signal to Noise Ratio | >100dB |
| Input Connectors | XLR, 1/4" TRS |
| Type | Power Amplifier |
| Power 2 Ohms | 2 x 1400W |
| Output Connectors | Speakon, Binding Posts |
| Input Impedance | 20kΩ Balanced, 10kΩ Unbalanced |
| Dimensions | 483 x 88 x 380 mm |
Describes the power switch and channel level adjustment knobs.
Explains LED indicators for signal level, peak, active status, and protection.
Details XLR, RCA input, and Speakon output connector types.
Explains the mode selection switch and the exhaust fan's function.
Specifies the connection for the IEC power cable.
Describes how the amplifier functions in bridge mode, doubling voltage swing.
Details how to connect speakers using Speakon connectors in bridge mode.
Illustrates a typical stereo setup with full-range speakers.
Shows an example of a mono bridge setup with a single speaker.
Provides details for connecting RCA and XLR balanced audio cables.
Explains the wiring for Speakon connectors for stereo and mono operation.
To Next Page
