Need help?Do you have a question about the Samson S63, S83 and is the answer not in the manual?
Details the main features of the Samson S83 and S63 mixer amplifiers.
Provides basic rules and tips for connecting the S83/S63 to other audio equipment.
Details how to use the Monitor output for independent mixes and the internal reverb unit.
Mixer / Pre Amp Section| total harmonic distortion | 0.045% |
|---|---|
| signal to noise ratio | 78 dB |
| maximum voltage gain (mic in to pre amp out) | 62 dB |
| residual noise (pre amp out) | -110 dB |
| tone control (high 10 kHz) | ±15 dB |
Power Amp Section| rated output power (4 ohm) | 300 watt |
|---|---|
| total harmonic distortion | 0.0045% |
| signal to noise ratio | 105 dB |
| frequency response (-1 dB) | 10 Hz - 28 kHz |
| input sensitivity / impedance | 1.2 V / 10 kOhm |
General| dimensions | 480 x 125 x 280 mm |
|---|---|
| weight | 31 lb • 14 kg |
| power requirements | 115 V AC 50/60 Hz 230/240 V AC 50/60 Hz |
Mixer / Pre Amp Section| total harmonic distortion | 0.01% |
|---|---|
| signal to noise ratio | 78 dB |
| maximum voltage gain (mic in to pre amp out) | 62 dB |
| residual noise (pre amp out) | -115 dB |
| tone control (high 10 kHz) | ±15 dB |
Power Amp Section| rated output power (4 ohm) | 200 watt |
|---|---|
| total harmonic distortion | 0.0035% |
| signal to noise ratio | 110 dB |
| frequency response (-1 dB) | 10 Hz - 28 kHz |
| input sensitivity / impedance | 1.2 V / 10 kOhm |
General| dimensions | 480 x 125 x 280 mm |
|---|---|
| weight | 29 lb • 13 kg |
| power requirements | 115 V AC 50/60 Hz 230/240 V AC 50/60 Hz |
To Next Page
