10
Rear Callouts
3 1 14
25
1. Input Connectors - Connect incoming signal to these electronically balanced XLR or
unbalanced RCA jacks.
2. MODE Switch - For normal operation, place this three-way switch in the STEREO posi-
tion. When placed in its BRIDGE position, the signal arriving at the Ch A input only
is again routed to both power amplifiers (the Ch B input is ignored), but the two
power amplifiers are bridged together.
3. Exhaust Fan - This variable-speed fan provides cooling to amplifier. Make sure that
both the front and rear panels are kept free of all obstructions and that cool, fresh
air is accessible at all times.
4. Speakon® Output Connectors - Use these to connect each channel of the amplifier to
your loudspeakers.
5. AC Input - Connect the supplied heavy-gauge 3-pin “IEC” power cable here
To Next Page
Loading...
