7
QKICK Wiring Guide
The QKICK can be connected to any mixer, mixer/amplifier, or mic preamp using
a standard microphone cable. As shown in the wiring diagrams below, connect
the female XLR end directly to the QKICK’s gold-plated connector and the other
end (normally a male XLR end, although some mixers use 1/4" connectors) to
the mixer, mixer/amplifier, or mic preamp.
QKICK Specifications
Type Dynamic Microphone
Polar Pattern Super Cardioid
Frequency Response 50~16000 Hz
Sensitivity -62 dBV/pa (0.8mv/pa)
Raded Impedance 200Ω
Max. SPL 147 dB (THD≤ 0.5% 1000 Hz)
Weight 370g
QKICK Specifications
To Next Page
Loading...
