Samson Servo 120 User Manual

12
Specifications
1. Rated Output Power, per channel (@ 1 kHz)
Stereo mode
4 ohm, .<0.05% THD+N 60 W
4 ohm, 1% THD+N 80 W
8 ohm, <0.05% THD+N 50 W
8 ohm, 1% THD+N 55 W
Bridge mode
8 ohm, .<0.05% THD+N 120 W
8 ohm, 1% THD+N 150 W
2. Typical Distortion, per channel
THD+N (80 kHz LPF @ 1 kHz, rated output power) .01%
IMD (SMPTE 4:1, 60 Hz & 7 kHz @ rated output power) .03%
3. Signal To Noise Ratio
(22 Hz - 22 kHz bandwidth @ dB below rated output power) 105 dB
4. Frequency Response 10 Hz - 20 kHz +0, -0.5 dB
3 Hz - 65 kHz, +0, -3.0 dB
5. Input Sensitivity +4 dBu to achieve rated power
(Level control set to maximum)
6. Crosstalk (adjacent channels) -75 dB, 1 kHz
7. Output DC Offset Voltage ± 50 mV, DC Servo Controlled
8. Headphone Output Level 15 mW (into 8 Ω @ 1% THD+N)
9. Dimensions (without rack ears) 17.5 in (w) x 11.5 (d) x 1.75 (h)
444 mm (w) x 292 (d) x 44 (h)
10. Weight 15.6 lbs • 7 kg

Samson Servo 120 Specifications

General

Signal to Noise Ratio	> 100 dB
Type	Stereo Power Amplifier
Channels	2
Frequency Response	20Hz-20kHz
Input Impedance	10 kOhms
Inputs	1/4" TRS
Outputs	Binding posts
Dimensions	19"